control cabin & workshop containers
The surface control and power supply equipment necessary to operate a Seaeye ROV can be provided boxed as individual transportable items or for you to install as a fixed installation in your vessel.
Alternatively, Seaeye can install all of this equipment into a dedicated control container or 'cabin' that can be moved from location to location as a complete and integrated unit. The package will include domestic power supplies, a desk, chairs and a bookshelf for the storage of system manuals. 19 inch rack mount units are provided with the Seaeye surface control unit installed as well as the installation of customer selected options such as a video suite, sonar control equipment, communications equipment and so on. The Seaeye Power Supply Unit will be installed together with all interconnecting wires and cables.
|Classification||A60 Zone II - ATEX Group II - Category 3G|
|Structural Build||Purpose built 'Offshore Service Container'
Load-tested, marked and certified to DNV 2.7-1 and BS EN 12079
|Certifying Authority||Lloyds Register of Shipping|
|Structural Materials||Bulkheads will be 4mm corrugated plate|
|Lifting Points||Fork lift pockets set into base, lifting padeyes to top corners.
ISO corners to base. 4 leg sling and shackles.
|Personnel access door||Outward opening, lockable A60 door, with 1900 x 850mm opening.|
|External Protective Coating||Surfaces shot-blast cleaned, primed, intermediate coating, top coating of 2-part epoxy paint.
Single colour to customer requirements.
Optionally: multiple colours and special requirements (logos etc).
Interior surfaces primed before insulation installation.
Roof with non-slip finish.
Underside protected with bitumastic black paint.
Sign written and marked in accordance with EN 12079.
|Passive Fire Protection||Bulkheads, floor and deckhead are insulated and lined with heat and fire retarding materials to SOLAS A60 standard.|
|Walls and ceiling||Walls and ceiling lined with non combustible Cape wall board, covered with fire rated white Formica sheet. Wall and ceiling boards are fastened with Omega Joints.|
|Cabin floor||Covered with DOT approved non-slip and fire retardant certified vinyl Altro flooring.|
|Heating & ventilation||A 1.5kW oil-filled heater is mounted near the pilot seat.
Ventilation is provided by the cabin pressurisation fan, via the inlet and exhaust duct.
|Cabin required supply||Electrical: 380-460VAC. 50/60Hz. 3-phase @ 63Amps. Neutral not required
Air: 80 to 120 PSIG. 2 Cu ft/min (for pneumatic dampers)
|Transformer||The cabin transformer is secured to the floor within an enclosure.
Input: 380 to 460VAC. 50/60Hz.
Output: 220VAC @ 5kVA single phase
|Electrical equipment||Cabin supply is via the Eex purge control unit into electrical distribution panel.|
|415V supply||AC 3-phase distribution panel, is fitted with RCD protection.|
|240V supply||AC single phase distribution panel is fitted with RCD protection.|
- EEx pressurisation / purge fan unit.
- EEx purge control panel, with smoke, gas, pressure monitoring and emergency shut-down.
- EEx solenoid valve for pneumatic inlet / exhaust dampers.
- Intrinsic cabin air pressure / flow switches.
- Magnahelic cabin pressure gauge.
- Intrinsic audible alarm, to warn of pressurisation loss & low level gas.
- One ceiling-mounted smoke detector.
- Intrinsic EEx gas detector head, mounted in air flow from pressurisation fan.
- Intrinsic break glass call point.
- EEx one ceiling-mounted emergency light.
- Wiring between EX units will be in ships wiring 685- TQ cable
- Escape hatch.
- Air conditioning.
- 19" rack rear access.
- Lifting sling.